Black Box Network Hardware RM516 User Manual

AUGUST 2000

RM516

RM517

RM518

RM519

RM520

RM521

RM522

RM523

Single/Dual Rackmount Kits

Description

Use these Rackmount Kits (part numbers RM516 through RM523) to mount any of several models of our

converters and line drivers in 19" racks. They can be used to rackmount either a single unit or two units side by

side. For help deciding which Kit is right for a particular product, call Technical Support at 724-746-5500.

The examples shown in this sheet for single- and dual-unit installations feature the RM523 Kit, which includes

one long and two short brackets, two side rails, and some screws and flatwashers. The same principles will apply

to all of the Kits.

Single-Unit Installation

The components that you’ll use for single-unit installation include one short bracket and one long bracket. To

attach each bracket to the unit’s case (the short bracket to the left side, the long one to the right side), use two

of the included screws and flatwashers, as shown below. Insert the screws in the two front holes on the unit’s

sides. (Nuts are already in place, mounted on the side walls inside the unit.)

Attaching the RM523 for single-unit installation.

After you attach the brackets, the unit is ready for mounting. Fasten the brackets to the side rails of your 19" rack

with four screws, cage nuts, etc. (These aren’t included in the Kit.)